here are some pictures of the console.







Close up of Cup holder, there is a gap under it that I plan on filling it with fiberglass panel and covering it in black leather.

 

very nice...did you encounter any problems?

 

Not really any problems just a few modifications. I had to make the switch plate 3 times before I got it where I liked it. Had to move the shifter over 1 inch to the driver side. Also the shifter cable was pushing up on the console in park, so I notched the plastic there, its not visible with the shift boot inplace. Other than that just some padding at the rear under the carpet, and some along the driver side to fill in the gaps.

I am going do dye/replace the radio pod with a black one to match the black console. I am glad I went black on the console in person it really sets off the interior.