I just installed a new bumper cover. While installing new Xenon headlights I noticed that the bottom screws that secure the bezel as well as the side adjustment screws are not accessable. The rubber is not as pliable and the fit is much tighter that previously.

Help, I don't want to wreck the cover but I don't see any way around it.

Jim

 

i had the same prob, i think i had my bumper cover tabs that go under the headlights on that side on the wrong side, and my bumper was bent so that didnt help. if you take out the top two screws and pull the bezel down you can put the square light in sideways then straighten it out... a littl annoying but can be done. or you can try to push down on the cover to access the bottom screws.