how to get seats out?
Thread Starter
Junior Member
Joined: Nov 2004
Posts: 74
Likes: 3
From: Gardner, ma
Car: 88 Trans Am
Engine: 305 tpi
Transmission: T5
how to get seats out?
all the bolts that hold the seat brackets to the floor are rounded off and i cant get them out, is there anyway to take the seat off the hinges or what? everything is rusted and stuck. WTF can i do?
Member
Joined: Oct 2002
Posts: 229
Likes: 0
From: Cheyenne, WY
Car: '89 Camaro RS
Engine: LB8 V6 MFI
Transmission: T-5 5-speed
Axle/Gears: 3.42:1
Try spraying/applying some PB Blaster penetrating fluid to the rusted/rounded off nuts a night before you attempt to take them off w/ the above said Vice Grips... good luck.
Supreme Member
iTrader: (1)
Joined: Dec 2004
Posts: 2,492
Likes: 0
From: Arcadia ,Ca
Car: 82 firebird s/e 83 Trans Am
Engine: 5.0L 305ci 4b carb.....CFI
Transmission: TH200C....700R4
Yeah,vice grips and spray some liquid wrench or PB blaster on there and you should be good to go
Thread Starter
Junior Member
Joined: Nov 2004
Posts: 74
Likes: 3
From: Gardner, ma
Car: 88 Trans Am
Engine: 305 tpi
Transmission: T5
tried all of the above, still no go. if i still cant get them off, maybe ill just grind the bolts off and weld the brackets to the new floorpan.*sigh* i pulled up a corner of a carpet looking for the floor, needless to say i didnt find it, HOLY RUST!! 
wait til i post up pix of the floor. its a good thing this car was free and i will be doing up the car in school.
wait til i post up pix of the floor. its a good thing this car was free and i will be doing up the car in school. Trending Topics
Member
Joined: Sep 2003
Posts: 132
Likes: 0
From: classified,ohmss
Car: 1982-z-28.1987 sc
Engine: 350 on z-28,305 on sc
Transmission: bw t-10 on z-28,700r4 on sc
use a torch to heat the nuts,then spray some wd 40 and go berserk with the vise grips,just be VERY,VERY careful not to torch the whole car
Thread
Thread Starter
Forum
Replies
Last Post
MrPackstin
Interior Parts for Sale
11
Oct 25, 2017 08:09 PM