Tools needed?
Thread Starter
Junior Member
Joined: May 2005
Posts: 96
Likes: 0
From: Florida
Car: 86 Camaro
Engine: 305
Transmission: 5 speed
Tools needed?
I'am going to the J/Y saturday to get a driver's side door. I need to know what type of tools to bring with me to get the door off with?
Thanks.
Thanks.
Senior Member
iTrader: (3)
Joined: Apr 2006
Posts: 518
Likes: 0
From: Hammond IN
Car: 1989 RS convertible
Engine: 305 TBI LO3
Transmission: TH-700-R4
Axle/Gears: stock axles 3.73 LSD
some wire cutters and a socket set. if you dont need the glass than you bring a hammer
Supreme Member
iTrader: (5)
Joined: Oct 2005
Posts: 1,775
Likes: 1
From: MA
Car: 1995 Formula; 1976 Trans Am
Engine: LT1; None
Transmission: T56; None
I'd bring some combination wrenches and a breaker bar, too. The wrenches can get into tighter spaces than the sockets.
Member
Joined: Jun 2005
Posts: 192
Likes: 0
From: indiana, pa
Car: 85 TA
Engine: dont wanna talk about it
Transmission: 700r4 for now
you dont need to take the spring out to get the door off
take the hinges with the door.....they unbolt from the body...but if you must seperate the hinges lonsal(on here) sells a tool to take them out or you can use a big screwdriver...very dangerous....i tied a wire to mine before i did this so it would go flying and stood way back....also if you are going to seperate the hinges your gonna need a dremel or something to take the pins out.....
take the hinges with the door.....they unbolt from the body...but if you must seperate the hinges lonsal(on here) sells a tool to take them out or you can use a big screwdriver...very dangerous....i tied a wire to mine before i did this so it would go flying and stood way back....also if you are going to seperate the hinges your gonna need a dremel or something to take the pins out.....
Thread
Thread Starter
Forum
Replies
Last Post