D A Problem
Thread Starter
Junior Member
Joined: Dec 2011
Posts: 45
Likes: 0
From: Wapakoneta, Ohio
Car: 85 Iroc
Engine: Don't have one yet.
Transmission: T-5 non wc
Axle/Gears: Disc brake 10 bolt with 373 gears
D A Problem
I'm having problems with my 80 grit psa discs flying off of my 6" DA sander. Anyone have this problem? Thanks
Senior Member
Joined: Feb 2005
Posts: 527
Likes: 5
From: Albany NY
Car: 84 Trans AM (sold), 87 IROC, 09 C6
Engine: Lt1 in IROC
Transmission: 5 speeds
Axle/Gears: Moser 12 bolt tru tracker 3.42
Re: D A Problem
are they the self adheasive kind or do you have a spray can? the self adheasive kinds don't have very much "stick" to them.....the surface of your DA needs to be pretty clean and dry before you stick them on there...give it another try!
Thread Starter
Junior Member
Joined: Dec 2011
Posts: 45
Likes: 0
From: Wapakoneta, Ohio
Car: 85 Iroc
Engine: Don't have one yet.
Transmission: T-5 non wc
Axle/Gears: Disc brake 10 bolt with 373 gears
Re: D A Problem
They are the self adheasive kind. I'll try to clean the sander and try again. Those things really fly when they come off. lol
Senior Member
Joined: Feb 2005
Posts: 527
Likes: 5
From: Albany NY
Car: 84 Trans AM (sold), 87 IROC, 09 C6
Engine: Lt1 in IROC
Transmission: 5 speeds
Axle/Gears: Moser 12 bolt tru tracker 3.42
Re: D A Problem
another trick i use sometimes is to try and start sanding on a flat surface with a brand new disc...it really helps it to get "stuck".....when removing them, they always come off better when they are hot....as in you just finished doing a panel....when they cool off they are quite stuck!
Thread Starter
Junior Member
Joined: Dec 2011
Posts: 45
Likes: 0
From: Wapakoneta, Ohio
Car: 85 Iroc
Engine: Don't have one yet.
Transmission: T-5 non wc
Axle/Gears: Disc brake 10 bolt with 373 gears
Re: D A Problem
It was a brand new pad. I cleaned it with some Mineral Spirits. Works great now. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
