Floor pan/Side Rust repair
Thread Starter
Junior Member
Joined: Nov 2012
Posts: 1
Likes: 0
From: Kansas City
Car: 89RS 305 TBI
Engine: 383 Stroker about to be dropped
Transmission: undecided
Axle/Gears: undecided
Floor pan/Side Rust repair
I have some decent floor pan rust that is creeping up the side of the car, on both side. A friend of mine and I are going to attempt to weld in some sheet metal unless anyone has any better ideas. budget is tight as i am a college student. is there an aftermarket piece that comes up this far on the edge? I also have UMI SFC's so im not AS worried about structural integrity.
Supreme Member
iTrader: (35)
Joined: Aug 2006
Posts: 1,470
Likes: 1
From: Mississauga,Ont,Canada
Car: 89 IROC
Engine: LSX 6.0 370, TU2 Cam, Fast intake
Transmission: T56 w/ lots of goodies
Axle/Gears: 8.8, Posi, 4.10, 31 Spline
Re: Floor pan/Side Rust repair
Common area fo rot on these cars. Sheet metal will be fine oryou can get a floor pan. Its up to you. Hows the rest of the floor?
Senior Member
Joined: May 2011
Posts: 855
Likes: 1
From: New Bedford MA
Car: 1988 Gta trans am
Engine: LR4 4.8
Transmission: 98-02 t56 6 speed
Axle/Gears: Bw 9 bolt (3.70’s) pbr rotors
Re: Floor pan/Side Rust repair
Wow i though mine was bad its really easy to fix that spot as long as u dont cut the whole rocker panel out u dont have to brace the car i recently did mine an the floor is very solid now ur best bet would try to find a non rotted floor an just cut it out of a junk car
Thread
Thread Starter
Forum
Replies
Last Post
