Front turn signal gap
Thread Starter
Junior Member
Joined: Apr 2013
Posts: 37
Likes: 0
From: Douglassville, PA
Car: 1983 Chevrolet Camaro Z/28
Engine: 383 Stroker
Transmission: T-5
Axle/Gears: Posi/3.73
Front turn signal gap
As you can see in this picture:
My front turn signals are not aligned properly with the holes in the bumper. Is there a way to adjust this so they line up correctly?
Thanks,
A.J.
My front turn signals are not aligned properly with the holes in the bumper. Is there a way to adjust this so they line up correctly?
Thanks,
A.J.
Supreme Member
Joined: Mar 2003
Posts: 1,615
Likes: 37
Re: Front turn signal gap
Have you tried swapping them? Move the left to the right side, and vise versa? (I didn't think you could mount them on the wrong side, but maybe you can.)
Maybe a shot further back will help too.
Member
Joined: Jul 2011
Posts: 146
Likes: 0
From: Brainerd, MN
Car: 92 Camaro RS, 93 Caprice Classic
Engine: 3.1L V6, 5.0L V8 + 700r4 on both
Transmission: Rebuilt 700r4 in the Camaro
Axle/Gears: Stock with 3.23s ...3.73 later?
Re: Front turn signal gap
Yup, looks like you've got them swapped. Should fit perfectly once you get them switched around lol
Thread Starter
Junior Member
Joined: Apr 2013
Posts: 37
Likes: 0
From: Douglassville, PA
Car: 1983 Chevrolet Camaro Z/28
Engine: 383 Stroker
Transmission: T-5
Axle/Gears: Posi/3.73
Re: Front turn signal gap
that's how they were when I bought the car. I'll flip em around tomorrow and let you guys know what happens 
Joined: Nov 2002
Posts: 6,644
Likes: 403
From: Oyth
Car: 89RS vert
Engine: Erod
Transmission: 4L65e
Axle/Gears: BW, 3.27
Re: Front turn signal gap
The lense & the arm down the center are marked L/RH.So you'ld be able to tell by looking.I dont think the arm would align with the screw hole if they were switched.
Thread
Thread Starter
Forum
Replies
Last Post
Fronzizzle
Suspension and Chassis
6
Mar 18, 2019 08:29 PM