Anyone here runnning a MTX 2300 amp
Thread Starter
Supreme Member
Joined: Oct 2001
Posts: 1,391
Likes: 0
From: Halifax, Nova Scotia Canada
Car: 1986 Camaro SC
Axle/Gears: 3.42
Anyone here runnning a MTX 2300 amp
if so, how do you bridge it with just one sub, and how do you do it for 2 subs,
i cant really figure it out
i cant really figure it out
Member
Joined: Apr 2001
Posts: 482
Likes: 3
From: UTAH
Car: 1982 Z28 & 1967 RS & 2002 Z28
Engine: 388 ci SB / 454 ci BB / LS1
Transmission: 4 speed / TH350 / T56
Axle/Gears: '91 "1LE" rear, posi w/ 3.23's
IN the picture you use the terminals in figure 16 and hook all your + wires from your sub to the "last" one of the 4 on the right, and all your - wires on the 2 one of the 4 on the right.. BUT WATCH YOUR IMPEDENCES, you WILL fry this amp if you run it long at 2 ohms bridged... my suggestion pay and installer to do it RIGHT for you the first time...
Supreme Member
Joined: Aug 1999
Posts: 1,437
Likes: 0
From: Lowell, MA
Car: 89 Camaro RS
Engine: sbc 400
Transmission: th350
i am actually running a MTX Blue Thunder at 2 ohms bridged without a problem. yeah, its not recommended, but these things are built pretty tough. since it is my temp amp and only cost me $75, i'm willing to risk it. but to be on the safe side, dont go below 4 ohms bridged.
Thread
Thread Starter
Forum
Replies
Last Post
raymondandretti
Electronics
1
Sep 27, 2015 06:43 PM
