Cooling System Wont Hold Water
Thread Starter
Member
Joined: May 2005
Posts: 329
Likes: 0
From: Stroudsburg PA
Car: 1987 Z-28
Engine: 355
Transmission: T-5
Axle/Gears: 10 Bolt/3.23 peg leg :(
Cooling System Wont Hold Water
I've just started noticing this, and it hasnt done it before. All stock pieces, rad., thermostat, waterpump. It seems like the coolant just evaporates, and disappears. Nothing is leaking, I've been under the car a few times since I've noticed this, seen nothing. There are no puddles under the car after its parked, and it seems to run at normal tempature. Everytime I fill up the tank, it disappears, where is all this coolant going?
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 12
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
"follow That Cloud!"
<CENTER><B>
Another it could be leaving is thru the exhaust pipe.</FONT>
</B><FONT COLOR=F3399><H5>
“If people drove any slower they’d be going backwards.”</FONT>
<FONT COLOR=FF66FF>NINÅ</H5></FONT>
<P>
<TABLE BORDER=9 CELLPADDING=8>
<TD BGCOLOR=black>
<B><H3><CENTER>REFUSE
TO
LOSE<p></TABLE></CENTER>
Another it could be leaving is thru the exhaust pipe.</FONT>
</B><FONT COLOR=F3399><H5>
“If people drove any slower they’d be going backwards.”</FONT>
<FONT COLOR=FF66FF>NINÅ</H5></FONT>
<P>
<TABLE BORDER=9 CELLPADDING=8>
<TD BGCOLOR=black>
<B><H3><CENTER>REFUSE
TO
LOSE<p></TABLE></CENTER>
TGO Supporter
Joined: Jul 2003
Posts: 4,803
Likes: 2
From: Grand Rapids, MI
Car: Z28
Engine: Sb2.2 406
Transmission: Jerico 4 speed
Axle/Gears: Ford 9" 3.60
It wouldn't be leaking into the exhaust, it would be getting burned off in a combustion chamber. Pull all 8 spark plugs and see if any look cleaner than the rest. Check the oil, too.
Head gasket, cylinder wall, cylinder head, intake to cylinder head.
Head gasket, cylinder wall, cylinder head, intake to cylinder head.
Thread
Thread Starter
Forum
Replies
Last Post
