Help with single fan. can't get it to work
Thread Starter
Member
iTrader: (4)
Joined: May 2006
Posts: 479
Likes: 1
From: New York
Car: 1987 IROC
Engine: 350 Gm H.O
Transmission: 700r4 built
Axle/Gears: 3.42 Locker
Help with single fan. can't get it to work
I have the main black, and black/red wires hooked up. Nothing. But there is a little connector on the passenger side of the radiator. I am not sure what wire goes there and if it needs to be on for my fan to work. Guessing its to tell the fan when to come on based on coolant temp.
How would I test to see if my fan is broken?
thanks
How would I test to see if my fan is broken?
thanks
Last edited by IROCJoyce; Aug 4, 2009 at 05:11 PM.
Member
Joined: May 2007
Posts: 237
Likes: 0
From: IL
Car: 88 IROC-Z
Engine: 5.7 TPI
Re: Help with single fan. can't get it to work
You only have one fan on that car? You could start by unplugging the fan connector at the fan itself. Find the proper terminals and apply power and ground to it straight from the battery. (Careful where you put your hands here)
Thread Starter
Member
iTrader: (4)
Joined: May 2006
Posts: 479
Likes: 1
From: New York
Car: 1987 IROC
Engine: 350 Gm H.O
Transmission: 700r4 built
Axle/Gears: 3.42 Locker
Re: Help with single fan. can't get it to work
Yeah I have the single stock fan.T hanks for the tip. My motor was shot so I went ahead and replaced it. The fan works good now. thanks!
Last edited by IROCJoyce; Aug 7, 2009 at 09:07 AM.
Member
Joined: May 2007
Posts: 237
Likes: 0
From: IL
Car: 88 IROC-Z
Engine: 5.7 TPI
Thread
Thread Starter
Forum
Replies
Last Post
sailtexas186548
Engine/Drivetrain/Suspension Parts for Sale
10
Aug 26, 2015 03:32 PM
