Around 6 monthes ago, i made a winaldl cable and downloaded winaldl on my laptop. It worked fine w/o a hitch. Now, the cable is missing and i made a new one. When i hook it up without the R3 and R4 resistor in place, i get only a couple lines of raw data reading. (car is an 86 lb9.) With the R3 resistor in place, i get all the sensor data but nothing more than that. All along, with either setup, i get the little red flashing 6 in the top of the winaldl box. The cable seems to be built to the same schematics as the one diagram that everyone has seen. Whats the deal? Anybody else have the problem of the little box at the top of the screen flashing red and reading 6? When i put in the R3 resistor, it turns green and reads 20 but still doesnt provide any data except the error codes and sensor readings.