DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

Code 43

Thread Tools
 
Search this Thread
 
Old Aug 29, 2004 | 03:26 PM
  #1  
albertschmitz's Avatar
Thread Starter
Junior Member
 
Joined: Jul 2004
Posts: 13
Likes: 0
From: Iowa
Car: 88 Roc
Engine: 305
Transmission: 700R4
Code 43

I replaced the IAC and set the low idle to 500 rpm, reset the TPS. I am still getting a code 43. When under load I get a slight ping/knocking sound. The check engine light comes on after a WOT run wen I lift. During the WOT run the engine seems to free up (i do not know another way to put it) and then the light comes on.

Runs great and idles perfectly now, but I would like to fix this issue with the car.

Car is a 88 IROC F 305 tpi.
Reply
Old Aug 29, 2004 | 03:31 PM
  #2  
Trickster's Avatar
TGO Supporter
 
Joined: Sep 2003
Posts: 6,127
Likes: 11
From: conway, s.c.
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
After adjusting your idle, you might also need to adjust your timing again.
Reply
Old Aug 29, 2004 | 05:15 PM
  #3  
albertschmitz's Avatar
Thread Starter
Junior Member
 
Joined: Jul 2004
Posts: 13
Likes: 0
From: Iowa
Car: 88 Roc
Engine: 305
Transmission: 700R4
Doh, I always forget the easiest things.

Thanks Trickster that was the ticket.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
89-IROCZ-5.0TPI
TPI
10
Feb 22, 2022 09:26 PM
Falcon50
DFI and ECM
81
Aug 22, 2020 03:26 PM
racereese
Tech / General Engine
14
Oct 3, 2015 03:46 PM
Luigytico09
TPI
0
Oct 1, 2015 08:46 AM
dusterbd
TPI
0
Sep 29, 2015 08:40 AM




All times are GMT -5. The time now is 07:55 AM.