Third Generation F-Body Message Boards

DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

WB wiring troubles on 749 ECM

Thread Tools
 
Search this Thread
 
Old Feb 17, 2006 | 03:35 AM
Share
  #1  
Spin City Turbo's Avatar
Spin City Turbo
Thread Starter
Junior Member
 
Joined: Feb 2006
Posts: 7
Likes: 0
WB wiring troubles on 749 ECM
According to Digware Technologies WB hookup page I use F14 for Vout on the WB controller and the WB controllers ground to B9. On my ecm plugs F14 is blank but B9 is VSS low input. what do I do?
Reply
0
Old Feb 17, 2006 | 09:55 AM
Share
  #2  
Z69's Avatar
Z69
Supreme Member
 
Joined: Sep 2003
Posts: 1,409
Likes: 1
From: Texas
F14 should be blank.
That's why it was picked.
The ecm gnd -which ever pin that is should work.
Reply
0
Old Feb 17, 2006 | 04:43 PM
Share
  #3  
Spin City Turbo's Avatar
Spin City Turbo
Thread Starter
Junior Member
 
Joined: Feb 2006
Posts: 7
Likes: 0
so I can just put the other wire to any ground terminal instead of to B9? that makes sense now. Thanks!
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
[TX] TPI setup
stalkier
Engine/Drivetrain/Suspension Parts for Sale
1
Dec 6, 2015 11:25 PM
1988 Trans am advice needed
stalkier
Electronics
1
Aug 21, 2015 01:54 AM
At a lost
djmarch
Tech / General Engine
3
Aug 19, 2015 12:07 PM
no power to dash and brake lights on
stalkier
Electronics
0
Aug 13, 2015 12:59 PM
'90 Firebird T/A no Speedo after replacing ECM
marcusaw
DFI and ECM
4
Aug 10, 2015 08:13 AM
Back to Subforum
DFI and ECM
View Next Unread
ecm swap woes




Advanced Search

All times are GMT -5. The time now is 08:09 PM.