Gen7 datalog question
Thread Starter
Junior Member
Joined: Mar 2006
Posts: 9
Likes: 0
From: Campbell, CA
Car: 70 vette roadster
Engine: 383
Transmission: tremec 5spd
Axle/Gears: 3.73
Gen7 datalog question
Question for the Gen 7 people,
I'm looking at my datalog graphs and I'm trying to figure out what the O2 feedback value would be if the actual AFR is equal to the AFR value in the table. The numbers I'm seeing range from .93 to 1.08. Does 1.00 mean no fuel is being added or subtracted? Do numbers above 1.00 mean fuel is being added and if the number is less than 1.00 then fuel is being subtracted?
Thanks,
Bob
I'm looking at my datalog graphs and I'm trying to figure out what the O2 feedback value would be if the actual AFR is equal to the AFR value in the table. The numbers I'm seeing range from .93 to 1.08. Does 1.00 mean no fuel is being added or subtracted? Do numbers above 1.00 mean fuel is being added and if the number is less than 1.00 then fuel is being subtracted?
Thanks,
Bob
Junior Member
Joined: Jun 2006
Posts: 37
Likes: 0
From: NA
Car: oldsmobile
Engine: 3.88
Transmission: yes
Axle/Gears: yes it has axles
Re: Gen7 datalog question
Yes Bob you are correct. Think of the # as a correction factor.1.0 means there is no correction needed to hit the target afr.
Thread
Thread Starter
Forum
Replies
Last Post