Third Generation F-Body Message Boards

DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

Where to put the holes...

Thread Tools
 
Search this Thread
 
Old May 4, 2012 | 03:24 PM
Share
  #1  
bonesbrakr's Avatar
bonesbrakr
Thread Starter
Member
iTrader: (3)
 
Joined: Nov 2007
Posts: 160
Likes: 1
Where to put the holes...
Planning on installing a Accel Gen VII this weekend and was wondering where everyone ran the wiring harness and or drilled thru the fire wall.....
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
350 and 305
Jake_92RS
Tech / General Engine
8
Jan 28, 2020 10:37 PM
DFCO not "working"
dyeager535
DIY PROM
7
Aug 28, 2015 08:10 AM
305 heads and or cam in 350?
michealleger
Engine Swap
5
Aug 26, 2015 03:29 PM
t5 clutch issue
87 camaro iroc
Transmissions and Drivetrain
5
Aug 20, 2015 07:47 AM
Confused about turn signal parts
Fronzizzle
Electronics
2
Aug 9, 2015 01:15 PM
Back to Subforum
DFI and ECM
View Next Unread
TIMING ISSUES WITH CAM




Advanced Search

All times are GMT -5. The time now is 11:58 PM.