DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

ECM qustions!! need help

Thread Tools
 
Search this Thread
 
Old Jun 30, 2013 | 08:56 PM
  #1  
88firebird400's Avatar
Thread Starter
Junior Member
 
Joined: May 2010
Posts: 26
Likes: 0
From: pine hill new jersey
Car: 1992 chevy camaro
Engine: 5.0 TBI
Transmission: 700r4
Axle/Gears: 3:73 n 4th gen rear
ECM qustions!! need help

I have a 1992 Camaro 5.0 TBI. I put the 4th gen rear in my car with 3:73 gears. my speedo is off and it says im doing 110 when im not. but im not worried about that. Here is my problem, the car shuts it self down. My question is how can I over ride this? I don't think these are flashable computers like the 4th gens. also who is good to send out my ECM for a chip or reprogramed to be able to over ride this problem? please help me out.
Reply
Old Jul 1, 2013 | 04:06 PM
  #2  
Tuned Performance's Avatar
Sponsor
20 Year Member
Community Builder
Community Influencer
Community Favorite
iTrader: (94)
 
Joined: Dec 2004
Posts: 16,740
Likes: 994
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: ECM qustions!! need help

if you can find the correct drive and driven vss gears go that route. A Dakota digital sgi-5 will also cure the issue with the fuel cut off. the prom can be reprogramed to raise the cut off to 255mph but it might be best to just address the cause and not mask the issue.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
InfernalVortex
Electronics
10
Apr 20, 2021 11:31 AM
Falcon50
DFI and ECM
81
Aug 22, 2020 03:26 PM
thunder57
LTX and LSX
1
Nov 7, 2015 02:28 PM
Jlanz55
TPI
2
Sep 29, 2015 08:55 AM
efiguy
Engine/Drivetrain/Suspension Parts for Sale
0
Sep 27, 2015 01:30 PM




All times are GMT -5. The time now is 10:47 PM.