Winbin help: ECU file error
Thread Starter
Supreme Member
Joined: Aug 1999
Posts: 2,441
Likes: 1
From: sweden
Car: GTA -89
Engine: Blown 415"
Transmission: 4L80E
Axle/Gears: Strange 12-bolt
Winbin help: ECU file error
I'm starting to look at the 8D code for my future 730 swap. But I keep getting "ECU file ERROR" and "Error in ECU file" in Winbin.
I use 8D definition file and AUJP.bin.
Any ideas?
Have searched but could find any useful info........
/N.
I use 8D definition file and AUJP.bin.
Any ideas?
Have searched but could find any useful info........
/N.
Senior Member
Joined: Oct 1999
Posts: 6,621
Likes: 2
Car: 91 Red Sled
Axle/Gears: 10bolt Richmond 3.73 Torsen
There are probably some spaces somewhere or a delimiter in the wrong place. Those are the frequent errors when using an ecu file that's been edited or opened in notepad. Get another ecu file from a good source.
Thread Starter
Supreme Member
Joined: Aug 1999
Posts: 2,441
Likes: 1
From: sweden
Car: GTA -89
Engine: Blown 415"
Transmission: 4L80E
Axle/Gears: Strange 12-bolt
I have downloaded from
http://www.area51.org.il/~zaphodb/gmecm/
Mike davis and DIY-GMECM sites
same results!
Can someone email me a 8D .ECU file that works, perhaps its my computer screwing it up...... but my 6E .ecu file works fine....
http://www.area51.org.il/~zaphodb/gmecm/
Mike davis and DIY-GMECM sites
same results!
Can someone email me a 8D .ECU file that works, perhaps its my computer screwing it up...... but my 6E .ecu file works fine....
Thread
Thread Starter
Forum
Replies
Last Post
KO1
Engine/Drivetrain/Suspension Parts for Sale
16
Oct 15, 2015 05:00 PM
