I would like to make sure that a newly burned chip has accepted my changes. I do not know how to get my pocket programmer 2 to feed back to the tunercat program so that I can look at what is on the chip. Can anyone point me in the right direction and have I given enough info to allow you to help. Thanks Scott

 

Select the 'Move Device' option. It reads the chip and fills the buffer. Then you can save the buffer to a file and read it with your editing program.

-dnult

 

Load the changed image into the PP2, and program the chip.

Then load the original bin file into the buffer, like you were going to burn the chip, BUT

Run verify devise.

It should list the locations and differences.