Problems reburning flash chips
Thread Starter
Joined: Dec 2000
Posts: 1,954
Likes: 68
From: NC
Car: 1987 Iroc
Engine: 357 Single plane and a Ysi vortech
Transmission: T56
Axle/Gears: 3.50 9"
Problems reburning flash chips
Anyone else here have to burn a flash chip 2-3 times(average) to get it to take? The 1st time it gets to the end 7F(something) and before it finishes I get a chip did not program error. It eventually take and works perfect. Any tips??
Thanks
Chris
Thanks
Chris
Supreme Member
Joined: Jun 2000
Posts: 7,554
Likes: 1
From: In reality
Car: An Ol Buick
Engine: Vsick
Transmission: Janis Tranny Yank Converter
Re: Problems reburning flash chips
Originally posted by NufNuffZ28
Anyone else here have to burn a flash chip 2-3 times(average) to get it to take? The 1st time it gets to the end 7F(something) and before it finishes I get a chip did not program error. It eventually take and works perfect. Any tips??
Anyone else here have to burn a flash chip 2-3 times(average) to get it to take? The 1st time it gets to the end 7F(something) and before it finishes I get a chip did not program error. It eventually take and works perfect. Any tips??
That's always worked for me.
Supreme Member
iTrader: (1)
Joined: Jun 2001
Posts: 1,520
Likes: 0
From: 600 yds out
Car: Bee-Bowdy
Engine: blowd tree-fity
Transmission: sebin hunnerd
Axle/Gears: fo-tins
That's exactly what mine does. I did fill the buffer with FF and program it from there a couple times. But that always took 6 tries. Not I just program right to it and it takes 2-3 times.
If you are talking about 29C256 like I'm using, you don't get the erase option for that in the Transtronics programmer.
If you are talking about 29C256 like I'm using, you don't get the erase option for that in the Transtronics programmer.
Thread
Thread Starter
Forum
Replies
Last Post