ARAP normally open fan request
#1
Member
Thread Starter
ARAP normally open fan request
I am currently using the latest Tunercat 6E def file and I can not seem to change the "normally open fan request" located in the "ecm switch table".
When I try to change it everything looks fine, but when I save the file and then reopen it the setting always reverts back to the normally closed state.
Has anyone else had this problem?
As listed in the tech articles, I downloaded the "Arap 6E.bin" from
ftp://ftp.diy-efi.org/pub/gmecm/bin_lib
Thanks
When I try to change it everything looks fine, but when I save the file and then reopen it the setting always reverts back to the normally closed state.
Has anyone else had this problem?
As listed in the tech articles, I downloaded the "Arap 6E.bin" from
ftp://ftp.diy-efi.org/pub/gmecm/bin_lib
Thanks
Thread
Thread Starter
Forum
Replies
Last Post