ZIF socket install help
Thread Starter
Member
Joined: Sep 2000
Posts: 235
Likes: 0
From: Sarasota, FL
ZIF socket install help
I bought a ZIF from the local electronics and I was going to solder it into my memcal. I think it's a pretty generic ZIF socket. There's no room for me to solder the ZIF pins to the memcal because the plastic covers them. The ZIF stays in the memcal under tension though. What do I do - leave it in under tension or get a ZIF that's easier to solder in?
Supreme Member
Joined: Jun 2000
Posts: 7,554
Likes: 1
From: In reality
Car: An Ol Buick
Engine: Vsick
Transmission: Janis Tranny Yank Converter
Originally posted by Aaron's 87:
I bought a ZIF from the local electronics and I was going to solder it into my memcal. I think it's a pretty generic ZIF socket. There's no room for me to solder the ZIF pins to the memcal because the plastic covers them. The ZIF stays in the memcal under tension though. What do I do - leave it in under tension or get a ZIF that's easier to solder in?
I bought a ZIF from the local electronics and I was going to solder it into my memcal. I think it's a pretty generic ZIF socket. There's no room for me to solder the ZIF pins to the memcal because the plastic covers them. The ZIF stays in the memcal under tension though. What do I do - leave it in under tension or get a ZIF that's easier to solder in?
Either way solder it.
Going around a turn or hard launch or in traffic is no where is set a code cause the chip fell out
Thread
Thread Starter
Forum
Replies
Last Post
