Car stalls when put in gear after warmed up
Thread Starter
Senior Member
Joined: Oct 1999
Posts: 6,621
Likes: 2
Car: 91 Red Sled
Axle/Gears: 10bolt Richmond 3.73 Torsen
Car stalls when put in gear after warmed up
I can't figure it out for the live of me. I checked the IAC and TPS, I reset them both (didn't need to) and then I changed the target idle w/ and w/o AC on to 950, that didn't work either. I can't figure out why the idle is all wack, I haven't changed anything on the chip or the car but I did notice that my alternator below 750rpm is turning on and off (from 14.3v to 13v) and the car surges a little to raise idle = more volts. What I can't figure out is why all of a suden the thing is sometimes hard to start (like battery is going dead but it's brand new red top with maybe 40 cranks on it) sometimes it fires right up, sometimes it sounds like it doesn't have enough power to turn it over. WTF is going on with my car? Everything was great until a couple of weeks ago! Please help me out guys, I'm going crazy on this one.
------------------
, Jon (350 TBI!)
91 Red My website
------------------
, Jon (350 TBI!)
91 Red My website
Thread
Thread Starter
Forum
Replies
Last Post
dhonda200
Transmissions and Drivetrain
6
Aug 11, 2015 11:50 PM





