VePHD Help! Almost got it!
Thread Starter
Junior Member
Joined: Apr 2005
Posts: 8
Likes: 0
VePHD Help! Almost got it!
I really like VePHD but can't quite get it to work. I have modded the vephddat.csv file to my TunerCat ecm's output.
The problem is that I run everthing fine, I get the output data and copy it over as stated to the VEPHDOUT (paste here) in the VEPHD VE Calculator.xls, I have the original bin in the Previous VE Table in the New VE Table Calculator (Tab) and from my understanding is that the new bin should now be updated but mine is not?
but i go to the new bin and i get nothing? I can email you a screen shot if you would like, I am sure that it is something simple I have attached a couple screen shots.
The problem is that I run everthing fine, I get the output data and copy it over as stated to the VEPHDOUT (paste here) in the VEPHD VE Calculator.xls, I have the original bin in the Previous VE Table in the New VE Table Calculator (Tab) and from my understanding is that the new bin should now be updated but mine is not?
but i go to the new bin and i get nothing? I can email you a screen shot if you would like, I am sure that it is something simple I have attached a couple screen shots.
Member
Joined: Jul 2003
Posts: 458
Likes: 2
From: Dallas
Re: VePHD Help! Almost got it!
I have been using a modified version of VePHD for the $0D mask for a few years now. You will find that it works well. It works best if you start off with a higher BLM correction factor at first, then use a smaller factor as the VE table starts to get roughed in. HTH
Thread
Thread Starter
Forum
Replies
Last Post
