Hi all,

I was just wondering if its possible to datalog SA? I'm running on a 7747.

Thx

 

When I ran winALDL a few years back I dont recall seeing SA shown on a continuous running basis. Just the MAP / RPM where KC appear on graph. In EBL Whats Up it does show SA on the display along with other sensors data. In the data analysis log it shows SA like evey .01/sec. I am running 89 octane now(92 prior) and seeing KC so will identify where and pull a couple deg.

 

On the TBI board see the "come in for a free tune" sticky. I'm fairly certain I outlined how to do it in that thread.

RBob.

 

Diacom and Datamaster both log SA off the ALDL

 

Thanks for everybody's reply.

Rbob, I could not find it in the free tune thread but I did find this.

https://www.thirdgen.org/forums/post...16-post31.html

Now, it could be I'm exhausted, but I'm not following what needs to happen.

specifically the
Addr: Value:
$D4E7 $00
$D4E8 $AB
$D4E9 $00
$D4EA $AC


Am I looking at the wrong items? the bin only goes down to $F4F.

Thanks again for everybodys help.

 

Last post in this thread explains it all:

https://www.thirdgen.org/forums/tbi/...ing-issue.html

RBob.

 

Ok, I think I understand

We need to change those addresses in winaldl right?

I was thinking we needed to modify the bin...

 

Opening line of the last post is "Since it's usually a one time deal I just edit the BIN directly and leave it. To do that open the BIN in Tuner Pro (TP) and open the hex editor:"

Previous posts describe the math for the PW and SA conversions.

RBob.

 

I'm Sorry Rbob, I feel like I'm beating a dead horse.

so for $D4E7 $00, It's not 0xd4e7h but Data address 4e7 correct? The bin is only 4k or 0xfff