block learn all over the place
Thread Starter
Junior Member
Joined: Aug 2005
Posts: 51
Likes: 0
From: Wisconsin
Car: 1951 Ford
Engine: Chevy 400 SB TPI
Transmission: 700R4
Axle/Gears: Ford 9 inch 373 gears
block learn all over the place
I just got my aldl hooked up and have been doing some logging with TunerPro rt. I am having a problem with the car when you put it to the floor it will flatten out and wont pull through??? I am trying to figure out if I am loosing spark or fuel????
Where do I start tuning???? I have noticed that my block learn is ALL over the board.
when the car is cool it stays at 128. As the car gets to operating temp it goes as high as 134 lean and then when slowing down or coming to a stop it will drop down to 120 rich. where do I start tuning this?????
Also at wide open throttle what should my spark advance rel to TDC look like when the tps% is 99
Sorry very new at logging this is my first try.
Where do I start tuning???? I have noticed that my block learn is ALL over the board.
when the car is cool it stays at 128. As the car gets to operating temp it goes as high as 134 lean and then when slowing down or coming to a stop it will drop down to 120 rich. where do I start tuning this?????
Also at wide open throttle what should my spark advance rel to TDC look like when the tps% is 99
Sorry very new at logging this is my first try.
Thread
Thread Starter
Forum
Replies
Last Post
MikkoV
TPI
2
Sep 9, 2015 04:25 PM