In the $32B program there's a Injector flow rate that I've changed to 42 lbs. Should the Display Injector Flowrate table also be modified to reflect this change using the following formula:
42 / 5.85 = 7.18 Gallons per hour? Factory programming being 3.81 GPH.

 

Not unless you have the driver information center (DIC) installed in the ******.

RBob.

 

This is in a 85 Vette converted to a 165 with a 434 running 10.94. I've changed the injector flowrate caveat, but was wondering what effect this Display injector table had. I've read that in 85 under the 6870 you would use injector lb rated divided by 5.85 for this value?

 

I'm you're tech support?

RBob.

 

Thanks!
Are there any reasonable people that may know this answer?

 

Why? Are you hoping that they may be your tech support? Scott Hansen...

This is a DIY board, one for the folks doing their own tuning...

Thread closed as your intents are not DIY.

RBob.