Turner Pro Won't Let me Do a New OBD1 Scan. It Just Replys My Old Scan
Thread Starter
Senior Member
Joined: May 2013
Posts: 604
Likes: 29
Car: 1986 Camaro IROC Z
Engine: LB9 305 TPI
Transmission: 700R4
Turner Pro Won't Let me Do a New OBD1 Scan. It Just Replys My Old Scan
I'm trying to do a new diagnostic with Turner Pro. I did one a year ago. When I load the XDF file, it just simply replays me old scan from a year ago. When I try to connect it says hardware not found, Not Emulating and DA not connected. How do I get it to scan?
Joined: Dec 2004
Posts: 16,772
Likes: 1,002
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Turner Pro Won't Let me Do a New OBD1 Scan. It Just Replys My Old Scan
Emulating ? You have a ostrich ? Sounds like the adx is setup wrong
Thread Starter
Senior Member
Joined: May 2013
Posts: 604
Likes: 29
Car: 1986 Camaro IROC Z
Engine: LB9 305 TPI
Transmission: 700R4
Thread
Thread Starter
Forum
Replies
Last Post
87SLEEPER
DIY PROM
7
Oct 7, 2013 07:53 PM
355tpipickup
DIY PROM
8
Sep 21, 2010 07:09 PM
SBNova
DIY PROM
43
May 27, 2008 07:59 PM