How does this hookup (fuel pressure guage)
Thread Starter
Member
Joined: Mar 2000
Posts: 218
Likes: 0
From: Toms River, NJ
How does this hookup (fuel pressure guage)
i ordered the autometer electronic fuel pressure guage (0-100psi) from summit.
now its part number ATM-3309.
anyone that got this already, does it connect inline w/ fuel lines? or on the fitting for the schrader valve????
-Stell
------------------
1988 IROC 305TPI MINT!!
Mods= Accell SuperCoil, MSD 6A, Ported Plenum, No MAF Screans
, K & N, 160 Thermostat+ Temp Switch
And Always Trying To Go Faster
now its part number ATM-3309.
anyone that got this already, does it connect inline w/ fuel lines? or on the fitting for the schrader valve????
-Stell
------------------
1988 IROC 305TPI MINT!!
Mods= Accell SuperCoil, MSD 6A, Ported Plenum, No MAF Screans
, K & N, 160 Thermostat+ Temp SwitchAnd Always Trying To Go Faster
Supreme Member
Joined: Jul 1999
Posts: 1,335
Likes: 2
From: Tucson, AZ, USA
Car: '92 Z28; Dk Teal; Her Pkg
Engine: 305
Transmission: Richmond 6 Spd
Axle/Gears: Moser 9", Detroit Locker, 3.70
The sender connects to the 1/4" flare fitting at the rear of the pass side fuel rail. You will need to remove the schrader valve, first. Before you remove the valve, crack the gas cap open to relieve the pressure in the tank, and if possible, remove the valve when the motor is cold.
Tim
Tim
Thread
Thread Starter
Forum
Replies
Last Post
R3500
Engine/Drivetrain/Suspension Wanted
1
Aug 17, 2015 12:16 PM
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM
