what is the ohms range of the fuel level sender? (E to F)

Reply Subscribe

Thread Tools

Search this Thread

Oct 14, 2000 | 01:15 AM

Jza

Thread Starter

Moderator

Joined: Jul 1999

Posts: 4,384

Likes: 2

From: Tulsa, OK

what is the ohms range of the fuel level sender? (E to F)

trying to calibrate my fuel gauge and i need to know which resistors to use.

Oct 14, 2000 | 07:31 PM

GMTech

Supreme Member

Joined: Jul 1999

Posts: 2,767

Likes: 2

From: Vereinigten Staaten

Car: Take

Engine: Your

Transmission: Pick

0-90 off the top of my head, not for sure though, don't have my manual handy.

------------------
If you live in Southeastern US, check us out!
South East Thirdgen

"I used to have a handle on life, but then I used it as a plunger and broke it" -The Wave

ASE Master Tech + L1
Savannah, GA
'87 Trans Am-K&N,Cold air induction, SSM SFC, Boxed LCAs, 8mm Accel wires, Flowmaster, 16" GTA rims.
'97 Bonneville SSE

Oct 15, 2000 | 01:49 AM

Tim Burgess

Supreme Member

Joined: Jul 1999

Posts: 1,335

Likes: 2

From: Tucson, AZ, USA

Car: '92 Z28; Dk Teal; Her Pkg

Engine: 305

Transmission: Richmond 6 Spd

Axle/Gears: Moser 9", Detroit Locker, 3.70

You are correct - good memory! 0 ohms at empty & 90 ohms at full are the values.

Tim

Oct 15, 2000 | 06:33 PM

GMTech

Supreme Member

Joined: Jul 1999

Posts: 2,767

Likes: 2

From: Vereinigten Staaten

Car: Take

Engine: Your

Transmission: Pick

I had a 50/50 chance. GM only uses two different senders. 0-90 and 80-240. 80-240 is used on newer vehicles.

------------------
If you live in Southeastern US, check us out!
South East Thirdgen

"I used to have a handle on life, but then I used it as a plunger and broke it" -The Wave

ASE Master Tech + L1
Savannah, GA
'87 Trans Am-K&N,Cold air induction, SSM SFC, Boxed LCAs, 8mm Accel wires, Flowmaster, 16" GTA rims.
'97 Bonneville SSE