Headlight problems
Headlight problems
Hi everyone.
Just bought a 91 Camaro. Love it so far, but have a couple problems with the headlights. Thanks in advance for any help.
I was driving the other day. (First time in the dark) Realized you had to hit the wiper switch pretty hard to go from low beam to high. That is the first question. What needs to be replaced to make that easy again. Just the switch or more? Next, I switched to low beam and they were completely off. High beam works perfect, but no low beam at all. Just was wondering what to do about that. I got flahed about 10 times on the way home, but not much I could do!
Thanks!
Just bought a 91 Camaro. Love it so far, but have a couple problems with the headlights. Thanks in advance for any help.
I was driving the other day. (First time in the dark) Realized you had to hit the wiper switch pretty hard to go from low beam to high. That is the first question. What needs to be replaced to make that easy again. Just the switch or more? Next, I switched to low beam and they were completely off. High beam works perfect, but no low beam at all. Just was wondering what to do about that. I got flahed about 10 times on the way home, but not much I could do!
Thanks!
well...i got the same problem with the switching high to low I think its just the switch but ill keep my eye on this thread for the answer from a more reliable source
...but for the headlights....1st check if wiring is all well connected... then u should chech if they are burnt out or not....after that....well....i dunno...maybe somebody else could help you out after that
...but for the headlights....1st check if wiring is all well connected... then u should chech if they are burnt out or not....after that....well....i dunno...maybe somebody else could help you out after that
Ya,
I am going out to check that right now. I don't think it is that thought because they were working fine until I switch high then back low beam. Crossing my fingers though. Anyone have an ideas?
I am going out to check that right now. I don't think it is that thought because they were working fine until I switch high then back low beam. Crossing my fingers though. Anyone have an ideas?
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM








