not sure where to post this......
Thread Starter
Junior Member
Joined: May 2001
Posts: 28
Likes: 0
From: Gadsden, Al,USA
not sure where to post this......
I need to replace the bulbs in the fog lamps on my GTA. What is the best way to do this? I searched the archives and found nothing. Can you just take the two torx screws that are visible out and do it, or is it more complicated? I even unbolted the front ground effect piece to see if I could get at it from the back. Or am I just not putting enough effort into it? Thanks a lot.
russ
russ
Senior Member
iTrader: (1)
Joined: Jun 2002
Posts: 502
Likes: 0
From: Indiana
Car: 91 Firebird Formula
Engine: ZZ4 fast burn with TPIS mini ram.
Transmission: Viper T10 6 spd.
Axle/Gears: 3.73
Yes if you take the screws out off the ends, the lens will come off then you can access the bulbs.
Thread
Thread Starter
Forum
Replies
Last Post
Linson
Auto Detailing and Appearance
26
Sep 21, 2015 01:08 PM
GeneralIesrussi
Tech / General Engine
0
Sep 3, 2015 03:23 AM