Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

Studder put put studder bleh....

Thread Tools
 
Search this Thread
 
Old Sep 12, 2004 | 12:05 PM
  #1  
83_Camaro_83's Avatar
Thread Starter
Supreme Member
 
Joined: Aug 2003
Posts: 1,352
Likes: 0
From: Calgary
Car: 1987 Z28
Engine: Tree Fiddy (modded)
Transmission: 700R4
Studder put put studder bleh....

My car is making that now! arg! I just did the timing chain i did the timing on the distributor.....But heres how it goes.....

If i havent started the car for a day or so i have to sit cranking the engine fr about 15 seconds, let off then try gain then the engine starts...... and then magically a new problem came up. I have its started then i watch as my rpms fall.....and fall....and my cars going studder.....and if i dont run to go give it some gas it just dies. and CHOKE comes up.... if i give it gas for a while then it remains stable again. BUT when i thought it was stable....i was drving around my block to make sure and just out of no where.....DIED....no sputter no nothing........what is wrong with my car


thanx......btw i dont know if its electronic so mods move it if you want....
Reply
Old Sep 13, 2004 | 10:35 PM
  #2  
Trickster's Avatar
TGO Supporter
 
Joined: Sep 2003
Posts: 6,127
Likes: 11
From: conway, s.c.
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
Have you checked the fuel pump?
Reply
Old Sep 13, 2004 | 10:40 PM
  #3  
83_Camaro_83's Avatar
Thread Starter
Supreme Member
 
Joined: Aug 2003
Posts: 1,352
Likes: 0
From: Calgary
Car: 1987 Z28
Engine: Tree Fiddy (modded)
Transmission: 700R4
no i have not but i did pick up a new distributor cap and rotor im gonna install tommorow.....and plugs and wires are brand new
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jake_92RS
Tech / General Engine
8
Jan 28, 2020 10:37 PM
dyeager535
DIY PROM
7
Aug 28, 2015 08:10 AM
michealleger
Engine Swap
5
Aug 26, 2015 03:29 PM
87 camaro iroc
Transmissions and Drivetrain
5
Aug 20, 2015 07:47 AM
Fronzizzle
Electronics
2
Aug 9, 2015 01:15 PM




All times are GMT -5. The time now is 11:48 AM.