A few weeks back, I had a problem with a code 45. The car would start then die instantly. I was told to check fuel pressure, TPS, FPR. Well it turned out that the Microtek MAF that I had replaced my old Bosch unit with had hit the crapper. I put my Bosch MAF back in, and it started right up with no stumbling or idle problems. So no more code 45, now i'm getting codes 22 and 33. I replaced the TPS with a new one, and set to .54 volt. The SES light comes on when idling, and when I accelerate, it goes off until I slow down again. It also seems to be idling kind of high. My tach has a short in it that cuts my ignition system out, so I don't know exactly what RPM the SES light goes off or on. Anyone help me with this please!!...I'm wondering if it isn't the ECM?

 

Try asking on the TPI board.

 

Did that, figured I might get a better response over here.