Battery Relocation Wiring
Thread Starter
Member
Joined: Dec 2003
Posts: 393
Likes: 0
From: Iowa
Car: 94 Camaro
Engine: 380 sbc
Transmission: th400
Axle/Gears: 9" 4.11
Battery Relocation Wiring
I'm starting to begin the wiring process on my battery relocation project.
So far I plan to run 2/0 guage cable from the battery - to the kill switch - to the starter. Then run a 6 guage cable from the starter to a distribution block to run to switches for guages ect.
My question comes here; How do i route the power coming from the alternator so it will still charge the battery, AND so when the kill switch is thrown, the car dies?
So far I plan to run 2/0 guage cable from the battery - to the kill switch - to the starter. Then run a 6 guage cable from the starter to a distribution block to run to switches for guages ect.
My question comes here; How do i route the power coming from the alternator so it will still charge the battery, AND so when the kill switch is thrown, the car dies?
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
run wire from the alternator back to the switch( rear of car) on the side that would be turned off...ie. would be connected to the battery + side.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
Street Lethal
Power Adders
634
Apr 30, 2019 12:14 PM
Dialed_In
Firebirds for Sale
2
Aug 20, 2015 01:45 PM
db057
TBI
10
Aug 11, 2015 10:11 PM
