Moving turnsignals in tails...How to wire up??
Thread Starter
Supreme Member
Joined: Oct 2001
Posts: 3,155
Likes: 2
From: Louisville, Ky
Car: 1991 Z28
Engine: 383
Transmission: T-5
Axle/Gears: 3.08 10 Bolt
Moving turnsignals in tails...How to wire up??
I want to move the turn signals from where they are located from the factory to the outtermost light in the tails.
Does anyone know how to go about wiring the tails to accomplish this?
I want the outter most lights (new turns) to be on with the lights and then also blink when I hit the signals.
The turns have three wires running into them and the outter most taillight has two wires running into it...I did this on my Jetta but can;t figure it out on the Camaro.
Does anyone know how to go about wiring the tails to accomplish this?
I want the outter most lights (new turns) to be on with the lights and then also blink when I hit the signals.
The turns have three wires running into them and the outter most taillight has two wires running into it...I did this on my Jetta but can;t figure it out on the Camaro.
Thread
Thread Starter
Forum
Replies
Last Post
AkDrifted
Engine/Drivetrain/Suspension Parts for Sale
6
Aug 17, 2015 07:45 PM
db057
TBI
10
Aug 11, 2015 10:11 PM