Where do the rods that run down the column to the ignition switch go?
Thread Starter
Senior Member
Joined: Nov 2005
Posts: 577
Likes: 0
From: Tolland, CT
Car: '86 Camaro SC
Where do the rods that run down the column to the ignition switch go?
I replaced the ignition switch on my car, and now I'm stuck on where the 2 rods that run down the column go. I know they either connect to the ignition switch or have something to do with it, but I'm not exactly sure where they go. I checked in my Hayes manual and nothing was there on it, so I'm asking you guys. If anyone could give me an idea of what they connect to or where they go that'd be great, I wanna get this back together and running again.
-Thanks, Brandon
-Thanks, Brandon
Joined: Mar 2000
Posts: 5,703
Likes: 132
From: Orange, CA
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
One goes to the ign. sw. the other to the highbeam sw.
Thread Starter
Senior Member
Joined: Nov 2005
Posts: 577
Likes: 0
From: Tolland, CT
Car: '86 Camaro SC
That does nothing for me. Where on the ignition switch and high beam switch? I don't even know where the hell the high beam switch is. Is that the switch that's connected to the ignition switch?
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM