Hello again,

Another question on this dash swap, for the 91 dash I'm putting in I need to switch to a electronic speedo.

I got a VSS unit, and it has 2 wires on it. 1 is blue/org and the other is blk/white.

Do I just run these up and connect them to the wires on C100? I'm looking at a 92 C100 diagram D4 YELLOW says Vehicle speed sensor And E4 PPL Vehicle Speed sensor.

If I do just connect them to these 2 pins, since the colors don't match to what I have on the unit. Does it matter to which wire off the VSS hooks to on the C100?

Thanks again

 

Nevermind, I think I found the answer.

I hooked the VSS up to a drill, and then hooked the 2 wires up to Yellow and Purple wires. It didn't seem to make a difference to which wires they were hooked too, just both had to be connected.

Thanks again.