Horn HELP!
Thread Starter
Senior Member
Joined: Mar 2006
Posts: 633
Likes: 0
From: Point Pleasant, NJ
Car: 1987 Chevy Stepside
Engine: 350 TBI w/ a Cam
Transmission: 3 Speed Stick w/ granny low
Horn HELP!
I installed a grant steering wheel a few days ago and pulled it cause I felt it was off center. Now when I try to reconnect my horn setup it stops working. I replaced the relay and still nothing. I have searched up and down whats the next step? The contacts inside the steering column?
Thread Starter
Senior Member
Joined: Mar 2006
Posts: 633
Likes: 0
From: Point Pleasant, NJ
Car: 1987 Chevy Stepside
Engine: 350 TBI w/ a Cam
Transmission: 3 Speed Stick w/ granny low
HELP! MY dumb parents wont let me drive w/o a horn. BTW I did a grant steering wheel. Does anyone know how to pull the raw metal adapter that you first put on so I can check the wiring inside the column? Also when I was working on it I had the horn going off for a good 45mins on and off, mostly on. Could this burn my horn out?
Last edited by r0nin89; Oct 6, 2006 at 10:18 PM.
Thread
Thread Starter
Forum
Replies
Last Post
