Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

Cars wont start

Thread Tools
 
Search this Thread
 
Old May 6, 2008 | 09:56 PM
  #1  
Milliardoj's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2007
Posts: 27
Likes: 0
From: Houston TX
Car: 92 camaro
Engine: 350 TBI
Transmission: 700r4
Axle/Gears: 3.42
Cars wont start

I just baught 2 v6 firebirds both suffering with the same problem.
one is an 90 and the seconds one is a 95. The problem is when i go to turn the key nothing happens, security light blinks at me non-stop. Ive done some digging in the 95s wiring harness found an old viper alarm and spme bad fuses, all of which has been removed and replaced. Still nothing. I jumped a hot wire of the battery into the starter while spraying carb cleaner in the intake and started up just fine aslong as the carb cleaner was there...then it died again.

I havnt started trying to fix the 90 yet, in the cause i dont want to spend a crap load of money on it to find out everything i replace is fine. I seem to do that on my 92 camaro as is <<;;

any suggestions?
Reply
Old May 6, 2008 | 10:07 PM
  #2  
campin1983's Avatar
Senior Member
iTrader: (4)
 
Joined: Apr 2008
Posts: 676
Likes: 1
From: Crawfordsville, IN
Car: 1984 Camaro 'Vert
Engine: 350
Transmission: 700R4
Re: Cars wont start

Do the keys for these cars have the VATS chips on them? I wonder if that's the key to the problem? Occasionally if my key gets dirty, thats what happens, and it won't start until i clean it off. I doubt your problem is that easy to fix, but I'd suspect it may be something with that.
Reply
Old May 7, 2008 | 03:31 PM
  #3  
Milliardoj's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2007
Posts: 27
Likes: 0
From: Houston TX
Car: 92 camaro
Engine: 350 TBI
Transmission: 700r4
Axle/Gears: 3.42
Re: Cars wont start

plugged a scanner in for codes, dropped 1

Code 46 Passkey 2 error

what exactly is that?
Reply
Old May 7, 2008 | 03:35 PM
  #4  
campin1983's Avatar
Senior Member
iTrader: (4)
 
Joined: Apr 2008
Posts: 676
Likes: 1
From: Crawfordsville, IN
Car: 1984 Camaro 'Vert
Engine: 350
Transmission: 700R4
Re: Cars wont start

Yep, thats VATS. The key you are putting in doesn't match what the car was set for, so it won't start.
Reply
Old May 8, 2008 | 03:38 AM
  #5  
karl's-92'-z28's Avatar
Supreme Member
iTrader: (5)
 
Joined: Jan 2008
Posts: 1,127
Likes: 1
From: Paradise, Hawaii
Car: Too many cars
Re: Cars wont start

Yup try cleaning that little looking chip on the key.
Reply
Old May 8, 2008 | 10:26 PM
  #6  
Milliardoj's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2007
Posts: 27
Likes: 0
From: Houston TX
Car: 92 camaro
Engine: 350 TBI
Transmission: 700r4
Axle/Gears: 3.42
Re: Cars wont start

i got a vats/passkey 2 bypass module but i dont quite understand what im wiring it into...help!!!
Reply
Old May 10, 2008 | 10:12 PM
  #7  
tripingeorge3's Avatar
Member
 
Joined: Jun 2006
Posts: 241
Likes: 1
Re: Cars wont start

theres 2 white wires running from your ignition lock down under your steering column.those are the 2 wires that touch both sides of the chip on your key. you'd cut those wires under the column and connect your bypass to that
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Wade787b
TPI
2
Sep 29, 2015 01:15 PM
TheExaminer
Cooling
26
Aug 26, 2015 04:59 PM
86Base
TPI
14
Aug 8, 2015 01:34 PM
L98GTA87
Tech / General Engine
0
Aug 5, 2015 11:02 PM




All times are GMT -5. The time now is 04:15 AM.