Bad ignition switch??
Thread Starter
Junior Member
iTrader: (1)
Joined: May 2005
Posts: 84
Likes: 0
From: New Fairfield, CT
Car: 1987 Camaro
Engine: 305 v8
Transmission: 700r4
Bad ignition switch??
In my 87 Camaro, you dont need the key to start the car. you can actually turn the ignition and start the car with nothing in it. What component needs to be replaced, is it the ignition switch? My dad mentioned that it could be a cable OR the ignition switch. How hard is this job? Something I could do?
Member
Joined: May 2006
Posts: 115
Likes: 0
From: colorado
Car: 85 Trans Am
Engine: 383 ci
Transmission: 700R4
Axle/Gears: posi 342
Re: Bad ignition switch??
If your car does not have an Air bag it is very easy, get a steering wheel puller (buy or rent) purchase a new ignition switch. Pull steering wheel, remove the 3 screws holding the turnsignal switch and the 1 screw holding it to the lever. Carefully move the turnsignal assembly out of the way. remove the one screw holding the ignition switch in and pull out. Installation is the reverse.
Thread
Thread Starter
Forum
Replies
Last Post
