problem help??
Thread Starter
Member
Joined: Mar 2010
Posts: 110
Likes: 0
From: HURLEY, VA
Car: IROC-Z
Engine: 350 VORTEC
Transmission: T-56
Axle/Gears: 4.10
problem help??
i took my speedometer out an then 1 day lader i put it back in know when i turn my turn signal's on they don't blink they stay on soild???? help? inty one lol
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
I Can Blink, Therefore I Can Speed
There’s no way to know from here what you might have touched.
Turn the key to the RUN position.
Turn the signal stalk to the left turn position.
If your left and right have the same problem, connect a voltmeter to the light blue wire at the connector on the lower right side of the steering column.
(It’s the longer-flat nearer to you of the 2 connectors in that area.)
Is there power there?
Now measure the dark green wire in the same connector.
Is there power there?
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
Turn the key to the RUN position.
Turn the signal stalk to the left turn position.
If your left and right have the same problem, connect a voltmeter to the light blue wire at the connector on the lower right side of the steering column.
(It’s the longer-flat nearer to you of the 2 connectors in that area.)
Is there power there?
Now measure the dark green wire in the same connector.
Is there power there?
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
“After The Fourth Barrel Roll I Lost Control Of The Car”
.
“After The Fourth Barrel Roll I Lost Control Of The Car”
.
Joined: Aug 1999
Posts: 19,282
Likes: 103
From: Lawrence, KS
Car: Met. Silver 85 IROC/Sold
Engine: 350 HO Deluxe (350ci/330hp)
Transmission: T-5 (Non-WC)
Axle/Gears: Limited Slip 3.23's
Re: problem help??
Did you reseat the cluster properly--and tighten the two 10mm nuts?
JamesC
JamesC
Thread
Thread Starter
Forum
Replies
Last Post
