The title I think speaks for itself. Why is it my cruise control isnt working? I recently replaced alot of the fuses which fixed most of the electrical but cruise is still broken.

 

Mine doesn't work either. I think it's the switch on top of the clutch or brake pedal misaligned, just need to get under there and fix and/or replace it. Might be worth a look for you to check that out too.

 

I am having the same problem. Just replace the push rod bushing on my clutch thinking that would fix the problem. When my old bushing broke off, The cruise stopped working. It was zip tied for about 2 months. I figured the clutch was resting on the senser. New bushing went on and nothing happened... Senser possibly stuck? Let me know if you discovered anything

 

If it helps anyone, here's the wiring diag for cruise: http://www.austinthirdgen.org/mkport...se_control.jpg

Wiring diags for almost everything are here: http://www.austinthirdgen.org/index.php?pid=19

 

i just fixed mine the other day, turns out it was the swich in the signel light lever. i replaced the lever and now it works perfect.

 

The two most common causes are the brake light switch on the arm of the brake pedal and the cruise control module behind the passenger side dash.

 

I have been looking for my cruise control module.. You state that it is on the passenger side. Take off protector panel. It is located up by the ecm? I still don't see it.

 

Its about 4" square 3/4" thick mounted on the end of the heater box on passenger side. It's a tight fit to get to, but you should'nt have to remove any dash parts.

 

Thank you. Found it.. Kinda tricky to get out.. 3 screws and a little wiggling.. But she came out..