Cruise control wiring

Reply Subscribe

Thread Tools

Search this Thread

Aug 27, 2010 | 09:11 AM

candy burple rs

Thread Starter

Junior Member

Joined: Jun 2004

Posts: 92

Likes: 0

From: hollywood maryland (st. mary's county)

Car: 87coupe,91RS Camaro's, 00 Suburban

Engine: LSX427HO w/D-1SC and intercooler

Transmission: RPM Tremec T-56 Magnum

Axle/Gears: DTS 12bolt, 3.42

Cruise control wiring

One more time, I have a 91 camaro with factory cruise control in it and have stuffed a LSX427 w/D-1 on it into the car. The motor came from Mast Motorsports with a full harness and computer(M-90) also a wired Vette pedal.
I would like to know how to hook the Mast to stock harness up. The Mast has the wires coded but need to know what to cut and splice on the stock cruise. The vaccum doesn't have to be used.....Any ideas

tks for your time

Aug 27, 2010 | 02:48 PM

Pocket

Supreme Member

iTrader: (24)

Joined: Jun 2005

Posts: 8,117

Likes: 362

From: NC

Car: 91 Trans Am

Re: Cruise control wiring

90-92 cars have all the necessary cruise wires in a connector under the pass side of the dash near the ECM

C209 in this diagram
http://www.austinthirdgen.org/mkport...se_control.jpg

All 4 run to the TAC module in your DBW harness