R @ R tps,still getting voltage low code
R @ R tps,still getting voltage low code
i got a 22 code so i changed my tps,the harness was shot so i changed that to, still getting a code 22 but the car runs better,the light comes on when i start the car but it goes off when i drive the car, every now an then the car will bump or what could be a miss an the light will come back on,then it goes off after i drive for a minute,voltage at 5, checked harness with ohm meeter and got good readings, any help, please!!!!!!!!!!!
TGO Supporter
Joined: Sep 2000
Posts: 6,775
Likes: 27
From: So.west IN
Car: 87 Formula/ 00 Xtreme
Engine: TPI 305/ v6
Transmission: struggling t-5/ 4l60E
Axle/Gears: 3.08/ 3.23
Re: R @ R tps,still getting voltage low code
If your TPS is adjustable, key on, back probe the blue and black wire with a voltmeter. It (the blue wire) should read o.54 volts ± o.o8v with the throttle closed. The grey is your 5v reference.
You may have to use paper clips to get to the pins in the plug, some multimeter probes can't reach far enough to make contact.
You may have to use paper clips to get to the pins in the plug, some multimeter probes can't reach far enough to make contact.
Thread
Thread Starter
Forum
Replies
Last Post
777Shock777
Tech / General Engine
4
Oct 29, 2015 04:30 PM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM





