autozone halogen fog lights ok to use in stock wiring?
Thread Starter
Senior Member
Joined: Jul 2009
Posts: 523
Likes: 103
From: Morgantown, WV
Car: 1990 Trans Am
Engine: 5.7 350 HSR afr195 xfi268
Transmission: T5
Axle/Gears: 3.08 posi
autozone halogen fog lights ok to use in stock wiring?
Wondering if its safe to have these halogens in our stock wiring??? there identical to our stock fogs but use a halogen bulb instead. thanks for the feedback
Supreme Member
iTrader: (3)
Joined: Jun 2007
Posts: 2,359
Likes: 5
From: Pennsylvania
Car: 1992 Camaro RS
Engine: Rebuilt 350 going in after paint
Transmission: WCT5, 7k & counting behind the 350
Axle/Gears: 4thgen disc rear w/ 3.73 Posi
Re: autozone halogen fog lights ok to use in stock wiring?
What is the wattage rating on the bulbs? Take that number and divide it by 13. Then multiply by the number of bulbs(I'm guessing 2). As long as the number you get is below the rating of the stock foglight fuse then you will be fine.
Honestly, if they are 55 watt bulbs which is pretty standard, then you should have no problems.
Honestly, if they are 55 watt bulbs which is pretty standard, then you should have no problems.
Thread Starter
Senior Member
Joined: Jul 2009
Posts: 523
Likes: 103
From: Morgantown, WV
Car: 1990 Trans Am
Engine: 5.7 350 HSR afr195 xfi268
Transmission: T5
Axle/Gears: 3.08 posi
Re: autozone halogen fog lights ok to use in stock wiring?
thanks for advice almost positive its 55w bulbs but i figure to check
Thread
Thread Starter
Forum
Replies
Last Post
