Leds for my 86 iroc, suggestions?
Thread Starter
Member
iTrader: (2)
Joined: Jun 2010
Posts: 482
Likes: 3
From: SE Houston TX
Car: 1986 Iroc-Z
Engine: 355
Transmission: 700R4
Leds for my 86 iroc, suggestions?
Hey guys im looking to upgrade my cars lighting.
I found the following link for the cluster leds after doing a little searching.
http://www.superbrightleds.com/cgi-b...%2FWLED-x5.htm
Would those be the best choice for my gauges? Id like to get them in cool white. how many will i need?
I also want to put leds on my front parking lamps. Im not looking to do anything extreme like a whole led grid i just want a bright bulb in there.
Same thing with my tail lights, can someone point me in the right direction? Are tail lights even possible? I know stock they have the round locking bulb so im not so sure.
I saw a couple of people made led tail light grids but i just want a plug and play kinda deal with minor modifications if needed.
Help/input appreciated.
I found the following link for the cluster leds after doing a little searching.
http://www.superbrightleds.com/cgi-b...%2FWLED-x5.htm
Would those be the best choice for my gauges? Id like to get them in cool white. how many will i need?
I also want to put leds on my front parking lamps. Im not looking to do anything extreme like a whole led grid i just want a bright bulb in there.
Same thing with my tail lights, can someone point me in the right direction? Are tail lights even possible? I know stock they have the round locking bulb so im not so sure.
I saw a couple of people made led tail light grids but i just want a plug and play kinda deal with minor modifications if needed.
Help/input appreciated.
Last edited by J0hn_J0hn08; Oct 26, 2011 at 11:00 AM.
Joined: Jan 2009
Posts: 63
Likes: 1
From: Owensboro, Ky
Car: 1992 WS6 T/A
Engine: Turbo 383 with Holley Sniper
Transmission: factory 5 speed now Powerglide
Axle/Gears: Strange 12 bolt w/373 locker
Re: Leds for my 86 iroc, suggestions?
I'm not sure about the dash lights but I have led replacement bulbs in the side makers, turn signals, tail lights, brakes, and reverse lights. They use the factory light sockets and they all came from auto zone. Had to install some type of resistor from the turn signals to work properly but they were right next to the bulbs on the shelf. Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM





