Where do these wires go?
Thread Starter
Senior Member
Joined: Feb 2008
Posts: 634
Likes: 1
From: Orland Park,IL
Car: Chevrolet Camaro IROC-Z,96 Vette
Engine: 350 5.7 Liter
Transmission: 700r
Where do these wires go?
First two are on passenger side. One is a single green wire a believe, the other one with two points is gray and black (with purple/pink stripe)
The other one is on the drivers side, that is black and tan (with black stripe.)
Please help it is well appreciated.
The other one is on the drivers side, that is black and tan (with black stripe.)
Please help it is well appreciated.
Joined: Dec 2004
Posts: 16,753
Likes: 996
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Where do these wires go?
first one looks like egr temp switch and egr solenoid, the other maybe mat
Supreme Member
Joined: Jul 2009
Posts: 2,328
Likes: 9
From: Kitchener, ON
Car: 1988 GTA
Engine: LB9
Transmission: T5
Axle/Gears: 3.45
Re: Where do these wires go?
pic#1: The 2 pin is the EGR solenoid, the 1 pin is the EGR feedback switch.
pic#2: Not sure, but I think this might be the infamous "it goes nowhere" mystery connector.
pic#2: Not sure, but I think this might be the infamous "it goes nowhere" mystery connector.
Senior Member
Joined: Nov 2001
Posts: 915
Likes: 2
From: Erlanger, KY
Car: 1989 Iroc-z
Engine: 350 TPI
Transmission: Auto 700R4
Axle/Gears: 9 bolt - 2.77
Re: Where do these wires go?
Second pic might be the air temp sensor wire connector. On my iroc, there is a jumper harness that plugs into a connector in that area of the engine bay and then runs under the plenum to the air temp sensor. I think thats what the connector looks like for the jumper harness to plug in to. Dont know if your 87 iroc will be the same as my 89.
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
3
Jan 9, 2017 04:06 PM
