Install oil pressure sender
Thread Starter
Member
Joined: Apr 2011
Posts: 128
Likes: 0
From: Adelaide
Car: '84 Trans Am
Engine: 305
Transmission: Auto
Install oil pressure sender
Hi all.
Now that i have the right oil pressure sender , how do you get it installed past the distributor?
Should it have an adapter so its at 90 degrees or something?
Cheers.
Now that i have the right oil pressure sender , how do you get it installed past the distributor?
Should it have an adapter so its at 90 degrees or something?
Cheers.
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Install oil pressure sender
Factory used several different ways of getting clearance
L98 Vette sender shown
L98 Vette sender shown
Thread Starter
Member
Joined: Apr 2011
Posts: 128
Likes: 0
From: Adelaide
Car: '84 Trans Am
Engine: 305
Transmission: Auto
Re: Install oil pressure sender
Mine is def up near the distributor. But does anyone know the type of adapter, size, thread etc, that the engine block takes?
Ebsy is looking my best bet because the stores here in Oz don't seem to keep any.
Ebsy is looking my best bet because the stores here in Oz don't seem to keep any.
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Install oil pressure sender
Any parts shop should have a range of brass fitting in 1`/8" NPT
http://www.ebay.com.au/itm/BRASS-FIT...item3cc72047f2
http://www.ebay.com.au/itm/BRASS-OIL...item19c16501b5
Thread
Thread Starter
Forum
Replies
Last Post
Navy8125
Engine/Drivetrain/Suspension Parts for Sale
4
Aug 21, 2015 09:32 AM
