VSS wires from dash
Thread Starter
Junior Member
Joined: Dec 2011
Posts: 92
Likes: 0
Car: 92 Z28
Engine: 350ci
Transmission: Th350
Axle/Gears: 3.73
VSS wires from dash
So I found out that there are no wires under my car near the tranny for the VSS and Im already doing the starter relay bypass can I find the speedometer wires under the dash where Im at now?
Supreme Member
iTrader: (2)
Joined: Jan 2001
Posts: 4,149
Likes: 3
From: Tampa, FL, USA
Car: 93 240SX
Engine: LQ9
Transmission: T56
Axle/Gears: 3.54 R200 IRS
Re: VSS wires from dash
The vss wires are part of the engine harness and run from the tail of the transmission along the harness through the fenderwell area, and to the ECM, looking under the dash if you dont see the pigtail plugged into the transmission isnt going to help you right now.
Joined: Dec 2004
Posts: 16,754
Likes: 996
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: VSS wires from dash
your profile says you have a th350 ? you said in your other post that it has been converted to a carb. if you are using the stock ip you will need to get a vss buffer and vss.
http://tpiparts.net/inc/sdetail/7586
http://tpiparts.net/inc/sdetail/7586
Last edited by Tuned Performance; Oct 6, 2012 at 05:47 PM.
Joined: Dec 2004
Posts: 16,754
Likes: 996
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: VSS wires from dash
not all the wires will need to be hooked up on the buffer. you just need accessory power and ground to the buffer. signal and ground from a 2k vss and the 4k output from the buffer to the speedometer.
Thread
Thread Starter
Forum
Replies
Last Post









