SES Light Wiring
Thread Starter
Member
Joined: Jul 2011
Posts: 178
Likes: 0
From: Los Angeles
Car: 1987 IROC-Z Camaro
Engine: 305 LB9
Transmission: 700r4
SES Light Wiring
Going with an autometer setup, wondering which wires from the original cluster connectors are for the ses light, I think I probably have some codes, but I'm not sure. In any case it would be good to have. Thanks for reading.
Joined: Dec 2004
Posts: 16,895
Likes: 1,014
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: SES Light Wiring
If you are asking how to wire in a Ses ? One side of the light bulb goes to switched power usually a pink/blk wire at the ip cluster. The other side of the wire on the bulb goes to pin A5 of your ecm . This wire will be found at the ip it is brn/wht.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
